Assistive Fidget Box

Assistive Fidget Cube primarily intended for academic settings where disabled or non-disabled students can utilize versatile faces with different textures and fidgets made by a PLA printer. Adult supervision required if faces are needed to be switched as there are alan screws holding each face in place and require some significant motor control to unscrew.

100% PLA Printed

Centerpiece + Alan screw: Print at 100% infill with supports + brim and alan wrench lying on a side face

2 prints: 6 Alan Screws + 2 Long nuts at 15% infill, no brim, no supports

2 Long screws at 20-25% infill, brim, no supports

Minimally 2 Prints: Groups for prints do not matter, brim, no supports, at 50% infill

Screw Each face into centerpiece after removing all supports and clearing out screw holes. Use short alan screws to secure each face individually in using the alan wrench. For the screw and bolt fidget, screw the long screws into the face with the threaded holes farther away from the head of the screws. Make sure to screw nuts onto screws once inserted through first holes in face.