How to Make a Device That Is Your Own Personal Tutor.

In this instructable, I'm going to show you how to make a personal tutor device that is ready to assist no matter the time,date,or location.

Here are the supplies that I used to create the product.

Bracket small

Power Drill

Metal Base

Three Screws One Small Screw two Large Screws

License Plate

Router

Packing Tape

Tablet

Tape Measure

Place the tablet face down on a soft surface.

With the tablet facedown.Screw the bracket to the top center of the tablet using the small screw and power drill. Use the pilot holes that are located at the top center of the tablet. Use a low setting on the power drill. Apply gentle pressure.

Using both your hands bend the license plate in half from the outside in. Be careful of sharp edges.

Place the metal base face down on a flat surface. Position the router underneath and secure it through the existing top-right pilot hole using the large screw and medium pressure until snug.

Place the tablet with the white back facing you and deploy the support rod. Measure 2 inches from the support bracket. Tape the license plate securely to the tablet, be sure the tape slices are slightly wider than the license plate.

Using the bottom bracket pilot holes, secure the router and metal base to the metal bracket with the small screw and a power drill. Apply medium pressure.

Once all the steps are complete.This is will be how your personal tutor device will look like.