Pet Toy Launcher

What we built was a pet cannon launcher toy. You put the ammo in the barrel, pull back on the wooden block and release the toy should come flying out of the barrel.

Cardboard,wooden blocks,hot glue,paint(optional) ,cardboard tubes,elastic bands,tennis ball (again optional)thinner card board,something to cut with,corks

First, get a piece of cardboard and fold it into a tube then glue it and put that tube into a filament spool for a 3d printer.

You can use anothing that will hold it together, we had an empty 3D filament spool.

Cut a slit in the tube and attach an elastic band to the barrel.

Get a paper towel roll and cut another slit into it and then hot glue a wooden block to the tube.

We put the rubber bands onto the handle then cut a slit so we could slide the tube into the barrel.

Take three corks and hot glue them together to make the toy that your dog or cat will chase.

We added some more rubber bands and then put a popsicle stick on the back with another rubber band then hot glued 3 corks together last we hot glued those together and onto the cannon.